Swap Fit

Swap Fit transfers settings from a fitting session to a hearing aid that may differ by product family, tier, style, or feature set. The response of the hearing aid from the fitting session is used as the “target” for the response of the destination hearing aid. All other settings (memories, feature settings, etc.) are transferred if there is a one-to-one match between hearing aids. Otherwise, the destination hearing aid will be set to default settings. Feedback Canceller, Real Ear Measurement, and Self Check initializations are not transferred, therefore; it is recommended you run these once Swap Fit is complete. If REM Target Match data already existed in the destination hearing aid, Swap Fit clears it. Swap Fit can also be used to transfer a previous hearing aid session programmed with older firmware to the same aid with newer firmware.

If swap fitting CROS/BiCROS products, a hearing aid fitting session can only be transferred to a receiver aid, a receiver session can be transferred to a hearing aid or a receiver aid if it's being paired with a transmitter, and a transmitter session can only be transferred to a transmitter (900 MHz only). If a receiver session is transferred to a hearing aid, all compatible user controls are transferred but CROS/BiCROS settings are not. If swap fitting a 900 MHz CROS/BiCROS fitting session to 2.4 GHz CROS/BiCROS devices, only the compatible user controls for the receiver aid are transferred. If swap fitting to a 2.4 GHz CROS/BiCROS receiver aid, the Power-On Delay is automatically set to Short if a different setting was selected previously.

This feature is available on all products except Xino Classic, Zōn, and Destiny. However, Xino Classic, Zōn, and Destiny products can be source hearing aids but not destination hearing aids.

1. Connect and select the desired destination hearing aid(s) via Get Started.

2. Click on the Read Device Settings or Load a Previous Session radio button and then click Start.

3. Click Tools from the Menu Bar.
4. Click Swap Fit.

   Note:  This feature is only available in a live fitting and for all products except Xino Classic, Zōn, and Destiny. Swap Fit is disabled if this feature is not available in the connected hearing aid(s).

   Tip:  Swap Fit will also launch automatically if you attempt to Load a Previous Session into a hearing aid that does not match the chosen fitting session.

5. Click on the session to transfer.

   Note:  Only sessions that are different from the connected hearing aid(s) displays.

6. Click Continue.

   Tip:  Click OK if this screen was launched from Load a Previous Session.

   Tip:  Click Cancel to cancel selecting a session.

7. Click Continue to begin Swap Fit.

   Tip:  Click Back at any time to go back to a previous screen or click Cancel at any time to cancel Swap Fit.

8. Select the receiver type, receiver matrix, connector, tube size, earpiece, earbud type, and/or vent size, if applicable, for the right or left aid.

   Note:  'Select Options' is only available for standard products. Both the selected and current session receiver type, matrix, and/or acoustic properties display. If swap fitting Evolv AI, Livio Edge AI, Livio AI, Livio, Halo iQ, Muse iQ, Halo 2, or Muse RIC hearing aids with SnapFit Smart receiver cables attached, Inspire automatically detects and defaults the receiver type and matrix, therefore, these options cannot be selected.

9. Click Continue.
10. Repeat steps 8-9 for the left aid if applicable.

    Note:  It's important to remove the hearing aid(s) from the patient's ear(s) prior to data transfer.

11. Click Begin Transfer.

    Note:  Do not disconnect the hearing aid(s) from the computer during data transfer.

12. Click Go to QuickFit once the transfer is complete.

    Note:  If 2.4 GHz CROS/BiCROS products were swap fit, connect and read the devices in Inspire to ensure the receiver and transmitter are paired.