QuickFit

QuickFit makes simple and quick adjustments to Occlusion Control, Low Frequency Gain, High Frequency Gain, Overall Gain, Output, Overall Soft Music Gain, Bass, Mid, and Treble, and provides shortcuts to other modules. Occlusion Control, Low Frequency Gain, and High Frequency Gain adjusts the overall gain at a range of specific frequencies, Overall Gain adjusts the overall gain, and Output modifies the maximum output. Overall Soft Music Gain adjusts the overall music gain, and Bass, Mid, and Treble adjusts the overall music gain at a range of specific frequencies for the Music memory in Honor, Pride, and Pride IIC products. The adjustment range for these products is -10 to +10. An entire curve, multiple frequencies, or a single frequency can also be adjusted graphically, except Music, by dragging and dropping points on the frequency response curve.

The QuickFit screen also provides quick links to Fine Tuning, Experience Level, Feedback Canceller, and/or Self Check. These links are only available if the hearing aid connected supports these features.

  1. Connect and select the desired hearing aid(s) to adjust via Get Started.

  2. Click on the Read Device Settings or Load a Previous Session radio button and then click .

  3. Click QuickFit.

    Tip:  Click via Fine Tuning to access.

  4. Click on the specific memory to adjust if applicable or click or to adjust all memories simultaneously.

    Note:  Click Information for information on adjusting the Music memory in Honor, Pride, or Pride IIC products.

  5. Inspire automatically defaults to a binaural Select Binaural or Select Binaural view if applicable. To adjust only the right or left hearing aid, click Select Right Only or Select Right Only, or Select Left Only or Select Left Only.

    Note:  If fitting CROS/BiCROS devices, only the receiver aid can be adjusted, therefore, the side cannot be selected.

  6. Click the up or down arrow keys to increase or decrease the overall gain or output binaurally or per ear side.

    Note:  For Honor, Pride, Halo, Z Series, 3 Series, Pride IIC, Xino, Wi Series, Ignite, X Series, S Series iQ, S Series, and E Series products with volume control adjustment capabilities, increasing gain will not affect reserve gain. For Xino Classic, Zōn, and Destiny products without volume control adjustment capabilities, increasing overall gain will affect reserve gain.
     
    Tip:  Adjustments can also be made graphically by dragging and dropping points on the frequency response curve. If Display Max Output Line on all SPL Graphs is not selected via General Preferences, maximum output cannot be adjusted graphically.

  7. Click Fine Tuning to fine tune the hearing aid(s).

    Note:  This button is available for all products except Xino Classic, Zōn, and Destiny.

  8. Click Experience Level to transition a new, inexperienced hearing aid patient from initial, spontaneously accepted gain settings to the final, desired, target gain settings.

    Note:  This quick link is not available if the hearing aid connected supports Auto Experience Manager. If the patient is less than 18 years of age, this feature is not available.

  9. Click Feedback Canceller to run the custom initialization measurement.

    Note:  This button is only available for Xino Classic, Zōn, and Destiny products. For all other products that support this feature, click Feedback Canceller from the Left Navigation Menu to access. If the patient is less than 4 years of age, this button is not available.

  10. Click Self Check or to execute a series of diagnostic tests on the hearing aid to check the integrity of the microphone, receiver, and Digital Signal Processor chip.

    Note:  This quick link or button is only available if the hearing aid connected supports this feature. If the patient is less than 4 years of age, this feature is not available.
QuickTIP